- Make sure this fits by entering your model number.
- TE extendable model; 18”-24” length
- Full steering and throttle control while sitting away from the motor
- Fits gas and electric trolling motors 15HP and under; designed for trolling speeds only
- Anodized aluminum, corrosion resistant fittings and unbreakable nylon clamp are designed to last
- Made in USA with a lifetime warranty
The HelmsMate Tiller Extension Handle allows you to sit away from your motor while maintaining full steering and throttle control. Slides directly onto the tiller handle of gas and electric trolling motors. Designed for trolling speeds only.
HelmsMate Features
- Clamps directly to the tiller handle for full steering and throttle control
- Fits most gas and electric trolling motors up to 15 HP
- Extendable models incorporate a stainless snap button to withstand the twisting motion from shift and throttle control (remove when not applicable)
- Anodized aluminum tube, marine grade hardware, unbreakable nylon clamp
- Made in USA. Lifetime warranty
Instructions for Use
Loosen thumb screws on the HelmsMate clamp, slide onto your tiller handle and tighten the thumb screws. For larger diameter tiller handles remove the rubber sleeve, pull open the clamp at the flanges and slide onto the tiller handle. For smaller tiller handles request the extra rubber sleeve that is available. Once clamped to your motor check to make sure you have clear access to the kill button on the motor.
For extendable models, adjust the length by pressing the snap button and sliding the inner handle to the desired length.